The new equipment is just starting to come into use and the products are starting to run in. The faults that may occur in the run-in period are more complex, and the causes may also be many, such as selection problems, design and manufacturing problems, or installation and environmental problems. If the torque is too small, it may affect the adjusting speed of the wind power tower shot blasting machine. In practical applications, there are the following: The design of the wind power tower barrel shot blasting machine does not pay attention to the solid connection between the connecting rod and the actuator, causing the phenomenon of falling off; When the power line and signal line are installed in the same threading pipe, the signal interference is large; There are large unshielded motor equipment nearby, which affects the stable operation of the motor; The safety type of position locator is too large, resulting in damage to the internal choke coil. Like these problems must be observed in time to find the problem and solve the problem.

The overall performance of the wind power tower shot blasting machine is changed from the running-in period to the adaptation period, and the performance is relatively stable at this time. The problems that arise are mainly quality problems caused by individual components. Such as current converter TAM2, intermediate contactor K1, K2, excessive torque of the micro switch and other small problems.

In the later stage of operation, the aging problem and wear problem of components begin to become extremely serious, such as the aging of the motor coil and the reduction of insulation, making the operation of the equipment unstable; Poor motor lubrication leads to a decline in stability; Aging of positioner coil or current converter leads to a decrease in positioning accuracy. The wear verification of the transmission parts of the reducer leads to the failure of adjustment of the shot blasting mechanical mechanism. For such problems, regular checks should be made to prevent major failures. Of course, in this series of failure factors, there are also some artificial stampede, baffle stuck, operation errors and other reasons in the operation of the work.